Ningbo Ousheng Electric Co., Ltd

High quality product, professional service,In an attitude of being responsible for the society, Ousheng Electric advocates environmental protection comprehensively.

Home > knowledge > Content
This is the characteristic of flexible cable
- Sep 26, 2018 -

The flexible cable is the preferred cable for the power transmission material and the signal transmission carrier in the drag chain cable motion system. It is also called the drag chain cable, the mobile cable and the robot cable. The wire structure of the cable is mainly a stranded copper wire structure according to the IEC 228 standard of the cable. The sheath is mostly made of a low-viscosity, flexible wear-resistant material, which is used to slow the wear rate of the cable in the continuous reciprocating movement.


Flexible cables can be divided into sensors, encoders, servo cables, robot cables, cables for cleaning cables, etc. according to their functions. Because of the many characteristics of flexible cables, the flexibility of cables has reached a higher level. Standard, when the cable is used, it is impossible to effectively change the cable due to environmental factors. The flexible cable is a shielded servo towline cable, which is resistant to oil, acid and alkali, and resistant to hydrolysis, ultraviolet rays and low temperature. When the cable is used, it will be very convenient to use the cable because of the above characteristics. The cable will also be used for a longer period of time because of these characteristics, and the cable will also be used because of more different usage rights. The application method is different, and the life of the cable is increased.

Compared with other cables, flexible cables are different from other ordinary cables. When installing, be careful not to damage the insulation skin of the cable. If the insulation is broken, it will accelerate the insulation of the cable. Oxidation. When the flexible cable is installed, the flexible cable cannot be twisted. That is, the cable cannot be unwound from one end of the cable reel. Instead, the cable should be unwound from one end of the cable. All cables should be unfolded first, necessary. When you hang it, the cable in this case can be obtained from the cable roll.

The cables must be loosely laid side by side in the towline, separating them as much as possible, separating them with spacers or using overhead separation space. The gap in the cable in the towline cable should be at least 10% of the cable value. Furthermore, it is impossible for the cables to be in contact with each other or to be trapped together. After both ends of the cable need to be fixed at two points, or the distance from the moving end of the cable should be about 20-30 times the diameter of the cable.


This is the characteristic of flexible cable

When the cable is bent, it is impossible to move it, so the distance between the cables will not change. After the relative operation, the position of the cable needs to be checked. After the cable passes through one end, it is best to check. The location of the cable, this check needs to be pushed or pulled or moved.